No Payments For 90 Days
Buy now, pay later for well qualified borrowers. Don't let heavy cost slow you down.
Buy now, pay later for well qualified borrowers. Don't let heavy cost slow you down.
The last reported number of hours was 48156. Hours and condition are captured at the time of listing and are subject to change. Please contact a representative about this piece of equipment for an updated reading.
Enclosed Cab
Air Conditioner
250 in Wide U-Blade w/ Dual Tilt
4 Cylinder Single-Shank Ripper w/Hydraulic Pin Puller
Rear Auxiliary Hydraulics
28 in Single Grouser Track Shoes
Serial Number / VIN: 4HK00462
Hour Meter / Odometer: 48156 hrs
Exterior Lights: Operational
Travel Alarm: Operational
Horn: Operational
Seat Belts: Operational
Hydraulic Controls: Heavy movement in control stick
Engine Oil Pressure: The gauge registers in the operating range.
Warning Lights: Operational
Gauges: Operational
Air Conditioner: Inoperable
Heater: Operational
Limited Function Check: The main components are in place and operational as noted.
Engine: No US EPA Label Present
A/C Compressor: Compressor will not engage
Blow-by (subjective visual observation): Minor
Starter: Operational
Oil Leaks: Side of engine
Fuel Leaks: No dripping leaks
Cooling System Leaks: No dripping leaks
Limited Function Check: The engine started and ran. Engine idles rough and surges.
Transmission: Operational, Oil accumulation, Unknown source
Limited Function Check (Drivetrain-Track): The drivetrain was operational without a load.
Hydraulic Tank: Low fluid level
Hoses (Hydraulics): Damaged sheathing on various hoses
Auxiliary Hydraulic Plumbing: Operational, Rear
Blade Lift Cylinders: Dripping leak on the left cylinder, Dripping leak on the right cylinder, Heavy pin and bushing movement
Blade Tilt Cylinders: Dripping leak on the left cylinder, Dripping leak on the right cylinder, Heavy pin and bushing movement
Ripper Cylinders: Dripping leak from all 4 ripper cylinders
Limited Function Check: The hydraulic system was operational.
Blade Condition: Heavy wear throughout blade. Various holes worn through and cracks in metal
Ripper Condition: Heavy wear throughout ripper assembly
Push Arm Pivot/C-FrameTrunnions: Heavy movement, Shims remaining
Tilt Linkage Pins and Bushings: Heavy movement
Blade Trunnions/bushings: Heavy movement
Limited Function Check (dozer): The main components were operational with movement as indicated., The main components were operational with damage as noted.
Belly Pans: Belly pans are dented heavily. Heavy oil accumulation on belly pans, Unknown source
Left Grouser Height: 28 mm
Left Track Bushings: Bushings have not been turned
Right Grouser Height: 28 mm
Right Track Bushings: Bushings have not been turned
For your convenience, we've included these documents free to download so you can make the best decision.
9236 hours
$145,000
6023 hours
$39,900
7461 hours
$68,145
5746 hours
$126,784
1063 hours / 228 miles
$104,742
1884 hours / 471 miles
$100,755
4461 hours
$306,085
6134 hours
$169,247
9236 hours
$145,000
6023 hours
$39,900
7461 hours
$68,145
5746 hours
$126,784
1063 hours / 228 miles
$104,742
1884 hours / 471 miles
$100,755
4461 hours
$306,085
6134 hours
$169,247