IronClad Assurance
Inspected by IronPlanet. Your purchase is protected by our IronClad Assurance.
Inspected by IronPlanet. Your purchase is protected by our IronClad Assurance.
Buy now, pay later for well qualified borrowers. Don't let heavy cost slow you down.
2018 Cat D6T LGP Crawler Dozer The last reported number of hours was 8043. Hours and condition are captured at the time of listing and are subject to change. Please contact a representative about this piece of equipment for an updated reading.
Enclosed Cab
Air Conditioner
2017 US EPA Label
Requires Diesel Exhaust Fluid
163 in Wide PAT Blade
Paccar PA56 Winch
Drawbar
Rear Auxiliary Hydraulics
31 in Single Grouser Track Shoes
Serial Number / VIN: CAT00D6TLMH700463
Hour Meter / Odometer: 8043 hrs
Exterior Lights: Some not operational, 1 front light inoperable lights are not operational
Travel Alarm: Operational
Horn: Operational
Seat Belts: Operational
Safety Lock Out/Stop: Operational
Current Safety Manual: No
Current Operator/Maintenance Manual: Yes
Engine Oil Pressure: The fault indicator shuts off after the engine oil pressure rises.
Warning Lights: Operational
Gauges: Operational
Air Conditioner: Operational
Heater: Not operationally checked
Limited Function Check: The main components are in place and operational as noted. Grade control monitor and blade sensors are not included.
Engine: 2017 US EPA Label, Requires Diesel Exhaust Fluid
A/C Compressor: Operational
Blow-by (subjective visual observation): Visible
Starter: Operational
Oil Leaks: No dripping leaks
Fuel Leaks: No dripping leaks
Cooling System Leaks: No dripping leaks
Limited Function Check: The engine started and ran.
Transmission: Operational, Leaking near filter
Limited Function Check (Drivetrain-Track): The drivetrain was operational without a load., Oil leaking near transmission filter.
Hydraulic Tank: Low fluid level
Auxiliary Hydraulic Plumbing: Capped off, Rear
Limited Function Check: The hydraulic system was operational.
Blade Cutting Edge Condition: Reversible-not turned
Winch: Operational
Push Arm Pivot/C-FrameTrunnions: Shims remaining
Blade Trunnions/bushings: Shims remaining
Limited Function Check (dozer): The main components were operational in a limited check.
Left Grouser Height: 45 mm
Left Track Bushings: Bushings have not been turned
Right Grouser Height: 45 mm
Right Track Bushings: Bushings have not been turned
For your convenience, we've included these documents free to download so you can make the best decision.
278 hours
$202,000
6942 hours
$480,000
311 hours
$125,000
1063 hours / 228 miles
$104,742
1884 hours / 471 miles
$100,755
15744 hours
$1,149,000
64 hours
$210,000
19603 hours
$259,995
View more
278 hours
$202,000
6942 hours
$480,000
311 hours
$125,000
1063 hours / 228 miles
$104,742
1884 hours / 471 miles
$100,755
15744 hours
$1,149,000
64 hours
$210,000
19603 hours
$259,995
View more